Raising funds for a new project.

I have for sale the following:

An EJ257 2.5L with STI 5 Cylinder heads.

This has been built and running and has done approxiamtly 7000 miles.

This was built with:

11mm ARP Head studs
Roger Clark Motorsport Oil Pump
1.6mm Triple Steel Head Gaskets


As I say the engine is built and there is no need to run in.
The heads were built, valves ground and tolerances corrected.

The short motor is as it came from the factory and the two block halves have never been seperated.

I'm looking for £2000, collected.

I will also provide a reversed Version 5 inlet manifold for an extra £200.


Cheers

Daz

 

Whats the new project Daz?

Bump for a top guy

 

http://www.scoob.co.uk/typer/collection.jpg

Got a 2.0L CDB which is going to be bored and sleeved to run 2.5 pistons.

Got some spare V5 heads to build up.

so basically a V3 STI Type R powered by a closed deck 2.5 running 2 bar.

Or something along those lines.

A good platform to start from.

I bought the car which has slight front end damage.
It came with the following:
DCCD drivetrain
Tein Type HR Coilovers
Whiteline 24mm Rear ARB
Whitleline 22mm Front ARB
Uprated drop links
All interior except door cards
4 X Rota 17 inch rims with tyres, 1 is damaged beyond repair.

Paid £1000 for everything

 

Nobody want an absolute bargain then?

 

Awesome project Daz,
keep us updated

Bump for a pukka engine

 

Block Sold

 

hello have you got v5 or v6 sti head including cams?