Just remembered i have this lying around in the garage, was fitted to my car for a year or so with great results, i had the dump valve hole welded up to run without one (was using the super strong TD05 and had no problems running without one and it sounds cool too ) also went the extra mile and fitted some fans underneath to help with heat soak along with some heat reflective tape, you can rip all that off if you want but i'll leave it on for the sale. Looks a bit homemade but works





Not sure on price, around 200 i guess, the fans cost 30+ quid alone!
Pick up from Derby or i guess around a tenner for courier

 

will this fit a 1995 import?? dos ir have the brackets that fits it to the engine??

If so ill have 1st Dibs please

 

I think your inlet manifold will be a phase 1 so you might struggle, i just about fitted a STi5 TMIC to my phase 1 manifold but swapped to a phase 1.5 manifold to get that extra few cms to get this to fit

Brackets wise, it didn't need any as it's such a tight fit, i just made one to go to the top of the inlet manifold as you can see in the first pic.

 

This is now sold pending cleared funds, yadda yadda