bleed valve/dawes mbc fitting help
I know the bleed valve isn't advisable but has anyone got any fitting pics/instructions for one.
Am possibly going to go for the Dawes mbc could someone supply details on fitting and pics. Cheers:thumb: |
Much better off just getting a controller mate or remap aren't u ? I've never fitted one but drive a classic with one fitted the other day spiked at 1.4 hit boost cut and drop like a right nail .
|
bugie smuggler,
Don't fit one. unless u got money in bank. as ur engine WILL go POP. getting a remap is the safest way. take it from someone who no,s scoobymike |
:rolleyes:
|
Originally Posted by budgie smuggler
(Post 11320514)
I know the bleed valve isn't advisable but has anyone got any fitting pics/instructions for one.
Am possibly going to go for the Dawes mbc could someone supply details on fitting and pics. Cheers:thumb: Are you having the car mapped (or at least having the fueling checked) to accommodate the extra boost ??? |
Had a bleed valve fitted and set up on my old Focus RS, as already said it would hit full boost then drop like a nail, load of flat spots, Not very good to be honest and I wouldnt even put one near a Impreza!!:nono:
Leave them to the RS boys!!!:thumb: |
Originally Posted by budgie smuggler
(Post 11320514)
I know the bleed valve isn't advisable but has anyone got any fitting pics/instructions for one.
Am possibly going to go for the Dawes mbc could someone supply details on fitting and pics. Cheers:thumb: |
Bleed valves worst thing for a turbo car imo
|
Depends what the car is. My99/00 classics run stupidly rich on OE ecu so you can increase boost within reason. Newage i wouldnt fit one. Either way get it setup correctly on a rolling road to check the air/fuel mixture rather than just guessing it
|
lol bleed valve, just get an ebay chip they add 50bhp dont yah know..............all for £7.99
|
|
I had a dawes fitted to my last blob, I fitted it on the rollers, raised boost by 2psi, so got before and after graphs to lay on top of each other, only 1bhp difference in peak, but it gained 20bhp and 30lb/ft in midrange
:thumb: |
Ah the good old Dawes, those were the days. Used to good effect by John banks (a long time ago) and a lot of info on them if you search this forum. Basically connect between compressor cover outlet and wastegate, you lose all ECU boost control including limp mode boost.
You will find most posts on the Dawes are from a long time ago, I was using one 14 years ago to good effect, as mentioned previously (before newages came out) the classics run nice and rich open loop so a bit of extra boost set a bit before OE boost cut was cheap and easy power. But things have moved on TBH |
All times are GMT +1. The time now is 03:51 AM. |
© 2024 MH Sub I, LLC dba Internet Brands