Before refitting
Just had inlet manifold repowder coated any ideas on cleaning inside before refitting ?
|
Just had the same problem, I was told blow out with an airline but due to the rough surface inside the inlet there was loads of crap left. Ended up using carb cleaner and a rag, poking the rag down with a screwdriver from the throttle body hole, then turning over and doing the same from the inlet holes. Took about an hour and a whole can of carb cleaner to do it.
|
Originally Posted by wotagr8bigchief
(Post 10905437)
Just had the same problem, I was told blow out with an airline but due to the rough surface inside the inlet there was loads of crap left. Ended up using carb cleaner and a rag, poking the rag down with a screwdriver from the throttle body hole, then turning over and doing the same from the inlet holes. Took about an hour and a whole can of carb cleaner to do it.
|
Yeah that should do the trick, I had to re-fit mine same day so had no choice but bottle brush should defo be faster.
|
Ok mate thanks yours all back and working fine now?
|
No engines still out of mine, just got to fit my parallel fuel lines then its going back in. Hopefully early next week.
|
Originally Posted by wotagr8bigchief
(Post 10905542)
No engines still out of mine, just got to fit my parallel fuel lines then its going back in. Hopefully early next week.
|
All times are GMT +1. The time now is 11:28 PM. |
© 2024 MH Sub I, LLC dba Internet Brands