Smoothing polishing inlet manifold
 

Hi

Can anyone recomend a company that could smooth down an inlet manifold? It doesn't need to be fully polished, just smooth as a baby's bum ready for paint/dipping.

Thanks
Gez

Not that you're saying about powder coating, but beware.......

https://www.scoobynet.com/scoobynet-...ercoating.html

I remember reading this. My current manifold was ceramic coated by Zircotec (probably best in the business) I've got an idea, fancy something a bit different.

I've got no idea who did that guys manifold but they should be shot

Anyone got any recommendations?

A high build 2k primer will bury the rough finish and once flattened will be lovely and smooth. Use an etch primer to start with though being aluminum.
I've done a few painted inlet manifolds.

Thanks for the reply, it's got to be bear metal. No primers etc as its gonna be either dipped or coated

Which version Gez?
Like this but not polished?

http://i1215.photobucket.com/albums/...nifold/009.jpg

Exactly mate - fancy doing mine :thumb: paid obviously ;)

Which version? Same as above?

no, sewage mate - image attached

Sewage lol.
Do you have a drill? If so....http://www.ebay.co.uk/itm/Silverline...item53f081baa7

yep, i did make a start but didn't look like it was goon turn out right :)

Persistence is the key. It'd cost a fortune to bring me out of retirement :fight:.

Cheers mate

Why are some of the old TMIC's mounted at such an angle?