ScoobyNet.com - Subaru Enthusiast Forum

ScoobyNet.com - Subaru Enthusiast Forum (https://www.scoobynet.com/)
-   General Technical (https://www.scoobynet.com/general-technical-10/)
-   -   Loses power and engine juders (https://www.scoobynet.com/general-technical-10/944628-loses-power-and-engine-juders.html)

WAZ WRX 29 July 2012 03:55 AM

Loses power and engine juders
 
Hi guys,

I have a friend who has a turbo 2000 which as far as im aware is practically standard except for a nurspec full 3 inch stainless steel system, and an hks induction kit with a purple label maf sensor and a hks ssq bov. Whilst hes driving after a full throttle around 3k revs the engine starts to shake and juder and loses all power and eventually cuts out.

This has only started happening over the last few days, not to mention this person has had his car 4 aprox 6 months and hasnt serviced the car! Which i know that should be 1 of the first things on his list, but surely the car shouldnt judder, lose power and eventually cut out? Also this doesnt happen all the time either.


My guess is something to do with the coil pack or possibly the maf sensor but i just thought id ask you guys for what my fellow scooby mates may think it could possibly be.

All help and advice would be appreciated, thank you :)

Waz

MrNoisy 29 July 2012 10:26 AM

Most obvious question - is the car mapped for these modifications?
If not, get it mapped; TBH the HKS induction kit will be doing nothing for the car if it doesn't have a separate cold air feed and is mapped in as it'll be sucking in hot air.
I bought one for my old car when I first got it and knew nothing about Scoobs - needless to say, a month later I took it off and sold it and the car ran better.
I'd say the only mod worth making in that list was the Nur Spec, but you say it's a "full system" - do you mean just cat back, or do you mean it's mated to a decat centre, and decat downpipe? Again, it's worth getting it mapped if it's not just a cat back system.

Lastly - I've seen people in the past at my local Rolling Road complaining about similar issues and all were running the same HKS blow off valve, which led to idle problems or stalling. Solution is take it off and put the standard recirc valve back on. I've seen a bugeye, hawkeye and classic all with the same symptoms and all reported by going back to the standard valve the car ran far better.

If the car's not mapped for it it'll completely screw the airflow monitoring.

WAZ WRX 29 July 2012 12:27 PM

Hi and thank u for the reply. No the car is not mapped, and the car has a decated down pipe and centre section. Before the hks there was a baileys bov on it. As for the induction kit that was an ebay job.
Can i ask where is your rolling road as i also have a T2000 and would like to have it rolling roaded atm to see how much power mine is pushing but then also a remap. What are your charges 4 both? Im based in manchester, once again thank you 4 the reply.

WAZ WRX 29 July 2012 04:13 PM

Ok weve changed the hks back to the baileys bov, and it still seems to be doing the same thing!
It cuts out when it feels like it. We were at some lights eveything seems fine, we were on a hill as we went to set off it cut out, tried to giv it extra accelleration and again it cut out. Like i said earlier he had a purple label maf, could this be the possible cause? Or anybody else have any other ideas

DEATHLYREAPER 29 July 2012 04:20 PM

Get it mapped for the mods !

MrNoisy 30 July 2012 08:29 AM

Like the man said above it needs mapping.
These cars are not Saxos and you can't just stick stuff on and hope for the best, ESPECIALLY when it comes to airflow if unless you enjoy your car running lean.

You've changed to another dump valve. The OEM valve is a recirc valve and that's what you should fit.
The HKS air filter will be retarding your power and if you're running the wrong MAF I shudder to think how much damage your mate is potentially doing trying to run it with the wrong MAF for the car (assuming he's swapped it for no reason for one off a different car?).

Rolling road depends where you're based. I don't own one, I'm just a regular customer at my local one :)

WAZ WRX 20 August 2012 10:45 PM

Thanx for the info bugeye scoob,

Just thought id up date that the problem was with the boost solenoid pipes which were cleaned via a thread from the scoobypedia forum and the car no longer judders and runs nice and smooth.

MrNoisy 21 August 2012 08:47 AM

Ah the old brake cleaner into the solenoid fix eh?
Btw I would still recommend you get the car mapped for the mods above. Happy you solved this one

WAZ WRX 21 August 2012 11:59 PM

the owner is looking to sell the car and more then likely put the standard down pipe and exhaust system on and sell his Nur spec seperately as he's a traitor and seen an evo 4 that he wants to buy! lol each to their own aye! lol


All times are GMT +1. The time now is 09:37 PM.


© 2024 MH Sub I, LLC dba Internet Brands