ScoobyNet.com - Subaru Enthusiast Forum

ScoobyNet.com - Subaru Enthusiast Forum (https://www.scoobynet.com/)
-   General Technical (https://www.scoobynet.com/general-technical-10/)
-   -   question about remapping (https://www.scoobynet.com/general-technical-10/932483-question-about-remapping.html)

lanceuppercut 15 April 2012 05:40 PM

question about remapping
 
my car was remapped before i got it, probably because it had a full decat'd, i got a rolling road printout with the car showing its running at 270bhp which the rb5 never was.

my question is when remapped, would the mapper likely have mapped as far as it my parts could have taken it or would the remap likely to have been a consequence of adding those bits only just to making sure the bits that were added would work? (if that makes sense)

short version: is it likely that a mapper wouldn't safely remap to the car to its limits?

winston69 15 April 2012 05:42 PM

Really depends who mapped it

Yellow R 15 April 2012 06:33 PM

Personally I think your best bet would be to ring the company that mapped it to get a clearer picture of what was done to it, With some places you can go back for a tweak after you added few bits etc, As you are probably aware that proper tuners never push it to the limit as many cars are tuned down abit for reliability, But if its some back street garage they probably will push it to the limits but that's when you have things blowing up :)

lanceuppercut 15 April 2012 06:53 PM

i've got a reciept from powerstation uk ltd for a "ecutek remap" which was where it was done but other than that i have no details about what was done on the map itself except for a RR printout.

i'll give them a call tomorrow but afraid i'll come a-cropper if they explain what was done as i'm a total newb when it comes to cars!

assuming a standard PPP'd RB5 except for a lightweight race flywheel (or so the reciept says), a full 3" revolution decat and powertech induction (whatever that is!), does 270hp and 261lb/ft seem "right" from a remap?

Yellow R 15 April 2012 07:01 PM


Originally Posted by lanceuppercut (Post 10579506)
i've got a reciept from powerstation uk ltd for a "ecutek remap" which was where it was done but other than that i have no details about what was done on the map itself except for a RR printout.

i'll give them a call tomorrow but afraid i'll come a-cropper if they explain what was done as i'm a total newb when it comes to cars!

assuming a standard PPP'd RB5 except for a lightweight race flywheel (or so the reciept says), a full 3" revolution decat and powertech induction (whatever that is!), does 270hp and 261lb/ft seem "right" from a remap?

Yh that would be your best bet mate have a chat with them first then take it from there as to what you want to do with the car.
Reading what you have said for mods it sounds about right at them power figures..
Im sure thay had a Prodrive re-mapped ECU aswell as standard but im not 100% on that...

lanceuppercut 15 April 2012 07:10 PM

apparently the PPP package does change the ECU to make the car 240bhp, so around 30bhp from the mods sound right then.

Scoobyn 18 April 2012 03:21 PM

Those were the same mods I had done inc map on my last car and it was putting out the same power so I'd say it was right.


All times are GMT +1. The time now is 04:12 PM.


© 2024 MH Sub I, LLC dba Internet Brands