ScoobyNet.com - Subaru Enthusiast Forum

ScoobyNet.com - Subaru Enthusiast Forum (https://www.scoobynet.com/)
-   General Technical (https://www.scoobynet.com/general-technical-10/)
-   -   engine bay wiring loom,,,,,, help what goes where ? (https://www.scoobynet.com/general-technical-10/931607-engine-bay-wiring-loom-help-what-goes-where.html)

Ginge ! 08 April 2012 12:11 PM

engine bay wiring loom,,,,,, help what goes where ?
 
1 Attachment(s)
where does it all go to, also the little connectors, think one is the oil pressure switch but which one and what are the others ???


Attachment 56643

Primeiro 08 April 2012 12:18 PM

Where r u based bud?

Prob best to run over everything in person or on phone.

Let me know or can go through everything here if u wish.

Cheers

Stephen

JdcTypeR 08 April 2012 12:41 PM

Brown connector coolant temp sensor, the grey one above it crank sensor.
Not sure about the other two off the top of my head

JdcTypeR 08 April 2012 12:44 PM

Where you have them as coil pack etc I think the white one is for the knock sensor.

Ginge ! 08 April 2012 04:12 PM

1 Attachment(s)
im based in watford and work in alperton

wish i never took this apart

is this closer or even accurate ?

Attachment 56644

JdcTypeR 08 April 2012 04:51 PM

The single terminal connectors are oil pressure sensor and coolant temp sensor for the gauge. The one that is angled is oil pressure
What car is the loom off?

Ginge ! 08 April 2012 05:51 PM

its a v3 sti loom, oh when i took out the loom i had to cut a wire that was rather terrible soldered on to the passenger side look connector, anyone seen this before ?

the loom used to have the black spiral stuff with insulation tape on it and looked terrible so i recovered it in self amalgamating tape to tidy it up a bit

Don Clark 08 April 2012 07:04 PM

http://static.opposedforces.com/epc_...1494809103.png


More info here..............

http://opposedforces.com/parts/impre...ne_electronic/

Sprint Chief 08 April 2012 08:17 PM

From here:

http://i43.tinypic.com/s3zq0n.jpg

E1, Grey 8 pin, Bulkhead wiring harness
E2, Grey 12 pin, Bulkhead wiring harness
E3, Grey 16 pin, Bulkhead wiring harness
E4, blue 2 pin, purge control solenoid valve
E5, light grey 2 pin, injector 1
E6, dark grey 2 pin, injector 3
E7, grey 3 pin, idle control solenoid
E8, brown 2 pin, engine coolant temp sensor
E9, 1 pin, thermometer
E10, grey 2 pin, crankshaft pos sensor
E11, 1 pin, oil pressure switch
E12, grey 3 pin, ignition coil
E13, grey 3 pin, throttle position sensor
E14, grey 1 pin, knock sensor
E15, light grey 2 pin, camshaft position sensor
E16, light grey 2 pin, injector 2
E17, dark grey 2 pin, injector 4
E19, grey 1 pin, power steering oil pressure switch

Ginge ! 12 April 2012 07:39 PM

You know I introduced eurocarparts to that site when I worked there and totally forgot about it,,,,, which is bad as I work at a main dealer as a partsman

Cheers though very good help

Ginge ! 12 April 2012 07:49 PM

https://www.scoobynet.com/scoobynet-...ml#post8489134

How stupid do I feel that I posted up a link a few years ago


All times are GMT +1. The time now is 10:42 PM.


© 2024 MH Sub I, LLC dba Internet Brands