ScoobyNet.com - Subaru Enthusiast Forum

ScoobyNet.com - Subaru Enthusiast Forum (https://www.scoobynet.com/)
-   General Technical (https://www.scoobynet.com/general-technical-10/)
-   -   2003 JDM STI, MPH Converter, where? (https://www.scoobynet.com/general-technical-10/915391-2003-jdm-sti-mph-converter-where.html)

Twilight 01 December 2011 11:28 AM

2003 JDM STI, MPH Converter, where?
 
Hello,

The vehicle is 2003 Subaru Impreza WRX STI, JDM- version GDB-C.

I haven't found MPH converter in my car anywhere. Would anyone be able to help me?

The VSS connector and its wires were intact and no signs of converter. I have also removed the gauges to look for the converter, nothing there either. Is there some other places where importers will install the converters? Or is there a possibility that the whole VSS has been replaced by a UK- one?

Please let me know if you know something.

-Ville

The Pink Ninja 01 December 2011 12:22 PM

Usually found under the inter cooler on top of the gearbox, A 3 pin connector block, It's normally tapped into that, The converter should have 4 wires coming off it.

Twilight 01 December 2011 01:10 PM


Originally Posted by GAZ2293 (Post 10359471)
Usually found under the inter cooler on top of the gearbox, A 3 pin connector block, It's normally tapped into that, The converter should have 4 wires coming off it.

Hello Gaz,

Yes, do you mean the typical converter which is plugged between the vehicle speed sensor and the plug that leads into the interior harness. I couldn't notice it as the wires did look like oem ones.

Any more ideas?

eggy790 01 December 2011 01:37 PM

2003 will be electronic wont it so not like above?

daz1968 01 December 2011 04:30 PM

On my my05 jdm the convertor is on the back of the clocks

Twilight 01 December 2011 07:42 PM

Daz, do you mean inside the clocks or soldered in between the wire harness behind the gauges?

daz1968 01 December 2011 10:36 PM

Mine is a small black box soldered into loom behind clocks, I noticed it when I removed clocks to route the wires for my mic on the pillar for my hands free kit, was easy to spot
If car has been through sva clocks must have been converted

10bats 01 December 2011 10:40 PM

most mph convertors are fitted inline on the vss wiring coming from the gearbox, not on plugs so they will look factory but hard wired and soldered into the loom under the intercooler. i personally have fitted dozens of them and that is the easiest and fastest place to fit them.

Twilight 02 December 2011 06:24 AM

daz1968, yeah I know what you mean. Typically they are found around that area, however there wasn't anything there.

10bats, okay I have to look again since they might have been covered so well I wouldn't able to see it last time. I don't believe they would have changed the complete VSS in favor of the MPH converter.

I let you know,

Ville

10bats, do you know where I could reprogram my clock's odometer? It is a JDM unit with red dials and it uses different chip than the UK/EU- models and we couldn't alter the clocks because of it. Any ideas?

TINO.wrx 02 December 2011 09:11 AM

ive got some sweeping jdm STi clocks (04 to go on my 03 wrx) coming soon will I need to fit one of these to convert the clocks to mph:
http://www.ebay.co.uk/itm/SUBARU-SPE...#ht_2767wt_905

http://www.ebay.co.uk/itm/Speedo-spe...ht_2621wt_1065

thanks

10bats 02 December 2011 12:12 PM

twilight, where abouts in the country are you

Twilight 02 December 2011 12:27 PM

10bats, actually i'm in Finland. :)

Quite long away but any shop would do since I need to send the gauges over to UK then. ;)

10bats 02 December 2011 12:37 PM


Originally Posted by Twilight (Post 10360980)
10bats, actually i'm in Finland. :)

Quite long away but any shop would do since I need to send the gauges over to UK then. ;)


i have the name and number of a man who can, will pm you it if you want it

Twilight 02 December 2011 02:35 PM


Originally Posted by 10bats (Post 10360991)
i have the name and number of a man who can, will pm you it if you want it


Oh yes please, is it a private person or a company?

TINO.wrx 04 December 2011 05:24 PM


Originally Posted by TINO.wrx (Post 10360768)
ive got some sweeping jdm STi clocks (04 to go on my 03 wrx) coming soon will I need to fit one of these to convert the clocks to mph:
http://www.ebay.co.uk/itm/SUBARU-SPE...#ht_2767wt_905

http://www.ebay.co.uk/itm/Speedo-spe...ht_2621wt_1065

thanks

anyone??


All times are GMT +1. The time now is 03:08 AM.


© 2024 MH Sub I, LLC dba Internet Brands