Power?
 

What power can i get out of these mods on my 1993 wrx import?Standard CDB engine,harvey smith ported heades,stainless steel slip joint up pipe,3 inch decat down pipe,decat centre section 3 inch,Greddy back box,front entry TD05 16g turbo,440cc injectors,parallel fuel lines,fuel distribution block,Greddy front mount intercooler,Apexi induction kit,Hks blow off valve,sx fuel regultor,walbro fuel pump,Autronic ecu to run maf less+anti lag+launch control,14 piece samco blue hoses,quick shift,Blitz boost controller+Blitz power meter.;)

330 - 350 ish not sure what the max is with those injectors though.

I will be very happy with 330bhp.

Not sure your clutch / gearbox will be :lol1:

Depends on how well the engine has been looked after, im impressed it still has a cdb, most have holes in them when the rods eject the pistons through the sides :lol1: and a cdb doesnt make the strength, the rods and pistons do, the cdb just stops the flex, and you need serious power (500+bhp) before you even need to consider one.

Tony:)

Now now Tony, I'm sure you'd agree on reflection thats a bit of an exaggeration. MOST have been removed and sold to those looking to build high power engines, or scrapped inadvertently ;)

There are probably huge amounts of these sitting on peoples shelves as spares. I know at least two culprits of this who probably have 5 between them.

I have had the car for 8 years now.The engine has done 107.000 miles and has a oil change every 7.500 miles.It has a Exedy clutch and a standard wrx gearbox.I was hoping to get 320 bhp,then save up as much as possible for a 2.1 stroker kit and 6 speed gearbox.