management light
 

I've got a bug eye wrx and the engine management light is on,diagnostics said it was crankshaft positioning sensor. This was replaced and fault code cleared. But once the engine is started the same light and fault code re-appear. Anybody had the same problem? Any ideas?

Are you sure its crank and not camshaft sensor. If there was no signal from crank sensor it wouldnt start

What was the fault code number?

could be the wiring/plug corroded

I dont personally know what the code was,auto spark plugged in his laptop and the crank shaft was what it came up with. Car runs well and no problems at all with starting,idling etc. Just don't like the light being on.

It should go out after 5 re-starts. Typical Bug random CEL generator.

Bug DENSO ECU hates being near the rev limiter and throws CEL's. As mentioned it's usually a camshaft position sensor error (bet it was) . Try cleaning the sensor.......sometimes helps :)

Shaun

not to ask a daft question but what fuel are you running?
If i run anything other than s/unleaded the management light flicks on as if to say "dont be a skin flint, put some tidy juice in me"

Shaun

Maybe sound daft but whats CEL's? Scooby novice here.lol
It's run on both petrols,depends if its the gf or myself who fills it up.

CEL = Check Engine Light = Engine Management light = EML, they are all the same :)

Change in petrol shouldn't light a CEL, the ECU will pull timing / Ignition multiplier but no CEL.

Shaun

I must have a temperamental bug in that case then, only likes momentum 99

All bugs are a bit tempremental.......... The Bug DENSO ECU is a lot more capable than the Classic JECS item. By the time they hit 2003-4 the Japs finally managed to sort out the ECU :D

Shaun

Found out what the problem was. When getting diagnostics carried out use a main dealer,turned out all along it was the fuel ratio sensor. Light on dash is off and cars going great,smoother,better throttle response and better fuel economy. Not exactly cheap but job done.