JDM V3 STi ECU?
 

Finally got to the stage in my car modding plans where i'm thinking of getting a mappable ECU.

The car however boost to around 1.1 bar so before I put my hand in my pocket I thought it was time I lifted the carpet and had a look at what was fitted.

Bog standard 6S
http://i79.photobucket.com/albums/j1...dude/004-1.jpg

Do the internals look standard?
http://i79.photobucket.com/albums/j1...uedude/007.jpg
http://i79.photobucket.com/albums/j1...uedude/008.jpg

I am however puzzled by the block connector in the following pics.
http://i79.photobucket.com/albums/j1...uedude/010.jpg

The wires under my finger go into the block but nothing comes out?
http://i79.photobucket.com/albums/j1...uedude/011.jpg
It's held in place with black electrical tape, not something i'd have thought Subaru would have done?

Any ideas guys or am I just being a divvy?:lol1:

Completely Standard. My V3 Type R was exactly the same when I first got it.

Cheers Daz, I couldn't understand what the block was doing there just taped up.