driveshaft failure with pictures
my rear n/s driveshaft joint failed yesterday on the way home after doin my food shopping.
i've fixed the problem today but thought i would post up pics of the failed part as i've not heard of a joint going quite like this before :- http://img228.imageshack.us/img228/5085/topslv.jpg i then held the back part of the break together as it was the only part that still fitted:- http://img585.imageshack.us/img585/5759/sideo.jpg http://img340.imageshack.us/img340/1314/endm.jpg |
bet that went with a bang! never seen one fail like that.
|
Wow I've not seen that before, I'd expect that to happen as a result of a savage launch not on the way home from shopping :lol1:
|
wow, never seen one go there before.
|
aparently its usualy the cage inside that goes.
it had been making a small knocking noise occasionaly on accelleration which i intended to investigate this weekend. i thought it might have been a wheel bearing, but obviously not ! the car originaly was automatic. at some point it was coverted to manual, and then a low ratio RA box was fitted. so its current setup delivers more power to the rear driveshafts than it would have had in the past. all i can think of is there was a weakness in manufactue which the cars current setup made fail |
ouch bet that went with a bang
|
just a bit !
took me a few seconds to realise the wheel was still atached as i was half expecting to see it rolling off in front of me at the time ! |
Never seen anything go like that before:eek:
|
All times are GMT +1. The time now is 08:57 AM. |
© 2024 MH Sub I, LLC dba Internet Brands