tech help
hi every 1 can anyone help???
im in the middle of a rebuild can any1 advise me on what pistons to use for a ej25 crank n rods to fit a centre thrust ej20 close deck???? any advice would be appreciated cheers derrick :wonder: live life to the full only if you drive a scooby:hjtwofing |
Post this in general technical and you will get loads of help mate!
The scottish section on here is a bit dead at times :) Welcome to the forum btw! |
Thanks mate
|
Mahle for me.
|
Yea mate but wot size?
92.5 or bigger n do you know anyone with any ? thanks again derrick |
Sorry, but i'm struggling to understand how you get to the position your in atm, without knowing the answer to that question...?
|
what i know is i had my eyes on cosworth 92.5 but very expensive so looking for cheaper one but just about the same forged bot the wrist pin needs to be up 2mm ok
|
All depends on the size of the bore. Is it standard or bored out?
Also make sure you buy stroker rods (slightly longer than standard) Johnny. |
Are the longer rods actually needed ?
What's the difference.... 1mm? |
conrods
:cool: yea mate but the reason you want longer ones ie 2m tobe exact is to create low compresion ok mate more torque means more BHP:luxhello:
|
All times are GMT +1. The time now is 08:35 PM. |
© 2024 MH Sub I, LLC dba Internet Brands