hi every 1 can anyone help???
im in the middle of a rebuild can any1 advise me on what pistons to use
for a ej25 crank n rods to fit a centre thrust ej20 close deck????
any advice would be appreciated
cheers derrick


live life to the full only if you drive a scooby

 

Post this in general technical and you will get loads of help mate!

The scottish section on here is a bit dead at times

Welcome to the forum btw!

 

Thanks mate

 

Mahle for me.

 

Yea mate but wot size?
92.5 or bigger
n do you know anyone with any ?
thanks again
derrick

 

Sorry, but i'm struggling to understand how you get to the position your in atm, without knowing the answer to that question...?

 

what i know is i had my eyes on cosworth 92.5 but very expensive so looking for cheaper one but just about the same forged bot the wrist pin needs to be up 2mm ok

 

All depends on the size of the bore. Is it standard or bored out?

Also make sure you buy stroker rods (slightly longer than standard)

Johnny.

 

Are the longer rods actually needed ?

What's the difference.... 1mm?

 

yea mate but the reason you want longer ones ie 2m tobe exact is to create low compresion ok mate more torque means more BHP