ScoobyNet.com - Subaru Enthusiast Forum

ScoobyNet.com - Subaru Enthusiast Forum (https://www.scoobynet.com/)
-   General Technical (https://www.scoobynet.com/general-technical-10/)
-   -   1.7 Bar MAP Sensor (https://www.scoobynet.com/general-technical-10/848872-1-7-bar-map-sensor.html)

Glowplug 30 August 2010 01:14 PM
1.7 Bar MAP Sensor
 
Want to replace the MAP sensor on my MY '93 due the the loom being stretched at the sensor.

I'm not looking for any gains. I just need to know if i can fit, without any detrimental effects or other mods a later 1.7 bar unit?

I'm aware the wiring is slightly different but i can sort that :thumb:

dynamix 30 August 2010 03:23 PM
Yes

dynamix 30 August 2010 03:23 PM
Although it will need to be mapped on an ESL (or other ecu) for it to work

Glowplug 30 August 2010 03:36 PM
Originally Posted by dynamix (Post 9573467)
Although it will need to be mapped on an ESL (or other ecu) for it to work
Thanx Duncan. So without a remap it will just operate as the standard 1.2 sensor, yes??

I'm not looking to increase boost levels or cut point, just that i can get my hands on a 1.7 bar unit foc, but don't want to fit it if i have to make other changes :confused:

dynamix 30 August 2010 03:52 PM
No, it will misread until mapped and possibly not even run.

Glowplug 30 August 2010 03:57 PM
That'll do for me, I'll get an early one then. Thanx again Duncan :thumb:


All times are GMT +1. The time now is 05:56 PM.


© 2024 MH Sub I, LLC dba Internet Brands