jperkie |
07 March 2010 06:26 PM |
splutter problems!!!
hi all and thanks in advance, i have a uk turbo 2000 on an x reg which i have had for about six months, all work was done before i bought it all usal stuff like full stainless (turbo back) remap (scoobyclinic) and list goes on!! anyway i fitted an apexi induction kit about two months ago and bonnet scoop o/s all seemed fine until first bit of rain and hey presto coughing and spluttering under hard aceleration so paniced and booked the car in at powerstation they said water on maf take the scoop off done that and removed the intake pipe the other side of the maf to find quite a lot of water in the pipe cleaned it all out wiped the maf clean and dry refitted old vent and retried it seemed a lot better but i am still getting the spluttering when driven hard, do you think that bit of water on the maf could have caused it to fail?? if you put your foot down gradually but all the way it do'snt seem to splutter only if say your in second gear about 30ish and put your boot to the floor hard then it will do it but not evey time and when it happens it will do it in every gear! no cel light neither on dash and if you unplug maf car will cut out which is normal so it must be working????? also checked all boost pipes all seems good whilst i was at power station they did a power run which was 276 bhp which i was pleased with, pulls strong and well but i could do with some advice on this spluttering. thanks jamie. p.s sorry its so long but felt if i explained all then somone may be able to help thanks again.:confused:
|