induction pipe help
 

hi some help please

have brought this which was advertised to fit uk version 5/6

my car is a my00

circle one isnt on the OEM one so not sure what should fit to it

circle two should point straight out and not upwards

has anyone fitted one of these and can help me

http://i2.photobucket.com/albums/y26...1218-Blue2.jpg

cheers phil

I'm guessing you've just got the wrong pipe there - for a v7 perhaps?

Yup, that one is for a newage car. No.1 is the air dump from boost solenoid. This could be blocked off though.

Is it possible to remove the metal joiner on 2, cut the hose back to point straight out and then put the joiner back in?

this is the link that i got it from

Subaru Impreza Induction Pipe GC8 EJ20 WRX/Sti,Vers 5/6 on eBay, also, Performance Tuning Parts, Car Tuning Styling, Cars, Parts Vehicles (end time 28-Apr-09 00:01:10 BST)

deffo says ver6 uk

cheers phil

Looking at an SFS hose for a 99/00 car, it also has connection 2 as pointing upwards, so the only problem is connection 1.

Nick

think i will just run a feed from number one and hide it somewhere and put a bung in it.

been looking at my engine and notice if i change the next bit (circle in white in pic)on the induction to samco(the bit between the maf housing and the new pipe i have already got) then i need to find a place for a pipe that goes into the oem bit (comes from a round tub thing near the abs circle in red) so can i just plum that into number one??

http://i2.photobucket.com/albums/y26/phil739/CROP4.jpg

anyone