Hello techies

I'm trying to make a simple excel page so that i can accurately read the boost in psi from the voltage output of the MAP sensor.

I also want to set myself a target of differing boost levels, for example

If i want 15.5 psi held what sum do i use to get the voltage and visa versa.

I have read the various posts on the subject and none show the calculations i would need to enter for the varying ranges from 0.8v to 4.52 (-1bar to 1.5bar).

Cheers



Iain

[Edited by iain atkins - 2/18/2002 1:56:10 PM]

Someone must know, please......................

I posted about this on here or I-club recently. Will try and find link for you.

Bob Rawle said -1.0 to 1.8 bar linear 0.88 to 4.84V. Also see the DIY FCD thread for some figures which back this up, as well as my own figures.

voltage = 2.29 + ((boost in PSI)/10.2)

can't find the thread worked this out from above figures and converting bar to PSI with 14.5 factor.

Thanks John,

Will give it a go.

Cheers



Iain