ENGINE BREATHER PLATE
 

Apparently according to the subaru garage they suspect there is a small leak in the engine breather plate and oils coming out.Is this a major problem or not.....ive been scamed b4 by the garage and dont wana cop out unless it is 100% must do thing.It may not even be the breather plate???

Some with Engine Knoledge Please Help....:cry:

THANKS

Well with my limited amount of engine knowledge, I don't even know what a breather plate is. I know common places where oil might leak, the most common being the driver's side rocker cover gasket, but an 'oil breather plate'? What's that? If they've stitched you up before, take the car away and go elsewhere.

http://i2.photobucket.com/albums/y35...amsin001-1.jpg

i think this is it the oil separator cover. an engine out job if it is dont think i've ever seen it mentioned on here before about one leaking.where about roughly is the oil coming from under the car front,back or sides of engine?
rob

thanks for the replys guys...as far as i know thats all they told me.i couldnt see and oil anywhere they said it was an engine out job around 700 quid to sort out. they said it could leak on to the clutch quite scary...is this worth doin.??

thanks

if it was leaking i would have thought you have seen oil on the steering rack or on the bottom subframe .how much oil are you losing and what did the car go in for originally?
rob

it just went in for a check up..or health check as they call it.?

Sounds like you need a second opinion, where abouts are you? I'm sure there will be a trusted company not too far away that a Scoobynetter can recommend.

oxford

You could try Len at Subaru4You in Newbury then. He has been looking after my car for the last 5 -6 years. Subaru4you - an alternative to main dealers. Hope this helps.

thanks alot...:) will do

And correct me if I'm wrong but the worst that could happen if it leaks oil into the bellhousing is that the clutch will slip. Changing the clutch is a might-as-well job once you've got the gearbox off anyway. Or to put it another way, even if it is leaking oil, you might as well run it until it goes wrong as it'll be the same job whether you fix it now or later, and you might not need to do it at all. In my non-expert opinion of course.