ScoobyNet.com - Subaru Enthusiast Forum

ScoobyNet.com - Subaru Enthusiast Forum (https://www.scoobynet.com/)
-   Computer & Technology Related (https://www.scoobynet.com/computer-and-technology-related-34/)
-   -   Poor DSL line quality - time for a new modem? (https://www.scoobynet.com/computer-and-technology-related-34/479863-poor-dsl-line-quality-time-for-a-new-modem.html)

Richard Curtis 29 December 2005 02:16 PM

Poor DSL line quality - time for a new modem?
 
Since moving house a couple of months ago my previously reliable 2Mb line has been replaced by a crappy one that struggles to get above 1Mb.

I have done a line check from a different ISP which confirmed due to the distance from the exchange I would unlikely to achieve 2Mb speeds.

I have read somewhere that high end DSL modem routers can run specific setting for low quality lines (e.g. Draytek models).

Would this improve the speed over my D-link 604+ wireless ADSL router?

cheers

Rich

boxst 29 December 2005 02:45 PM

Hello

I have a Draytek modem/router and it doesn't appear to have that feature. You could always ask around and borrow someones and see if the line att. is any better when a different modem is connected?

Steve

jpor 29 December 2005 08:06 PM

I take it you have asked BT to do a line check? Just in-case the signal power can be upped or you have crappy cables that need replacing.

Richard Curtis 30 December 2005 01:16 PM

Done the checks - got a report back that it is within acceptable limits :(

It's just I'm quite far from the exchange.

Had some encouraging options from broadbandbuyer help yesterday - they recommend changing to active ADSL filters (type XF-1e at about £7.50 each), i read reports of them boosting the signal to noise ratio by 10dB.

Worth a try.

mike1210 30 December 2005 03:39 PM

maybe worth getting a broadband NTE. One box that does the filtering and then no more need for filters at all your outlets. Would be a big help if you are boarderline. Has an RJ11 for the phone and an RJ 45 for the ADSL, me dad made an RJ11 to RJ45 to connect to my draytek router at the time. It gave a 6dB increase in Signal to Noise ratio:)

TonyBurns 30 December 2005 07:35 PM

Its mainly down to degridation, either due to distance or when there was a copper shortage in the 70's/80's they use aluminium wire.
The DB can be adjusted but it doesnt mean it will improve your line quality, and in most cases, changing the end equipment will do nothing either.
BT are still researching ways of overcoming these problems, unfortunately they dont have a 100% solution at this time :( so your stuck in the same boat as me, 1mb broadband.... serves me right for living in the sticks ;)

Tony:D

PS, i will add that the ultimate thing is to add new equipment to the street furnature to enhance the signal, though it would mean replacing quite alot of street furnature in the process :(


All times are GMT +1. The time now is 07:52 PM.


© 2024 MH Sub I, LLC dba Internet Brands