Induction Kit on PPP 01 WRX?
 

Hi all

I have seen some mention that if you add an induction kit to a car with an ecu upgrade you need it remapping.

Well I want an induction kit on mine and have a PPP

What needs to be done, if anything??

Eric

Id bin the idea of an induction kit, they can cause maf failures due to vibration and the fact that you take in hot air instead of cold air....
An STi panel filter (the only official STi/Subaru Japan approved item btw) is a good alternative and will probably give you better results, not cheap at 50 quid and needs changing every year but i gained over 10bhp and 15lbs of torque with one of these (MY03 JDM STi Spec C).

Tony:D

being very thick here ....

I have a MY04 WRX PPP ...

What is the panel filter and where does it go ??

thanks

MArk

Tony, thanks for that.

Wheres the best place to get one of these filters?

The panel filter goes in the airbox situated on the LH side of the car.....

Try www.japanparts.com or www.stiracing.com (Simon Lau runs STi Racing and he posts on here.I ordered an STi filter from him and his service is very good!!)

Good luck

Nick

P.S: I run a green air filter in mine as recommended by TSL (The cheapest place to buy these is from Demon Tweaks)

Thanks Nick :)