ScoobyNet.com - Subaru Enthusiast Forum

ScoobyNet.com - Subaru Enthusiast Forum (https://www.scoobynet.com/)
-   ScoobyNet General (https://www.scoobynet.com/scoobynet-general-1/)
-   -   S.U.B.A.R.U Boot Badge location (https://www.scoobynet.com/scoobynet-general-1/3305-s-u-b-a-r-u-boot-badge-location.html)

Scott.T 03 July 2000 12:04 AM

I am soon to recieve a handfull of letters to make up the S.U.B.A.R.U boot badge.

Can anyone tell me the correct location (i.e distance from the bottom edge of the Boot) and the character spacing (character center to character center). Plu the overall width of the words SUBARU.

Cheers All...

The Zohan 03 July 2000 02:26 PM

It is a slow day at work so here goes.

on my MY 99 UK 4dr car it is as follows
50mm down to the top of the letters from the swage line (crease) in the boot lid - this equates to 120mm to the bottom of the letters to the bottom lip of the boot

letter spacing 23mm apart.

the SUBARU text is centered.

I have a few suggestions for you.

Lay out the letters on a flat surface and get the spacing equal @ 23mm spacing. Lay out a piece of masking tape below the letters and mark/indicate on the tape the letters and spacing onto the top edge of the tape for a reference. offer this up to the boot lid and get it centered and level and in a line with the top edge of the tape at 120mm from the bottom boot lip. You can then attach the letters evenly, centered and level.

Hope this helps.

Not a great explaiation i hope you get the gist.

P.S. i must be in a charitable mood as it was pissing down whilst i was measuring up!

Scott.T 03 July 2000 02:32 PM

What a guy.

That's much appreciated.

Just one thing tho. Are the letters 23mm apart - center to center or are the gaps between each letter 23mm.

I shall probably do as you mentioned with the masking tape...

Thanks again, and I hope you didn't get too wet.

The Zohan 03 July 2000 02:35 PM

It really is a slow day - -hope they do not check the Internet logs beforwe i delete my bitz!

The 23mm is letter edge to letter edge

i.e S--23mm--U

Good luck oh and just one question
are the letters elf adhesive or is it sillicone sealant time?

Scott.T 03 July 2000 02:40 PM

I'd not thought about using Silicone Sealant. I may try that.

I usually use the small double sided pads that are used for sticking rear view mirrors on (you can get them in halford). It's what I used for my now Red 'I' badge on the Front Grill.

The letters I have are second hand so they will probably need a clean up and then I'll use one of the above.

The Zohan 03 July 2000 02:44 PM

Check your e-mail in ten mins - picture to follow - may help

dave fairhurst 03 July 2000 03:02 PM

Paul

Have you nothing better to do?
What about all this hectic dashing round the country?!!!

Dave

The Zohan 03 July 2000 03:34 PM

Dave - good to hear from you - in a word NO - I was supposed to be off this week relaxing and stuff - sh*t hit the Fan Friday - Bloody clients and all that - came in today and done nufink!. Still off for the rest of the week bar a meeting tomorrow afternoon.

Fancy a beer this week - give me a call and i'll pop over - I have that Subaru World Rally promo on VHS if you would like one, i'll bring it with me - if your are up for it!

[This message has been edited by Paul Habgood (edited 03-07-2000).]

[This message has been edited by Paul Habgood (edited 03-07-2000).]


All times are GMT +1. The time now is 10:47 AM.


© 2024 MH Sub I, LLC dba Internet Brands