please could anybody help,

torque settings for complete engine rebuild,
engine is 3SGTE model from 1991 car,
has anybody got them or let me know where i can get them

cheers, Andy

I have a Toyota Repair manual for the 3S-GE, 3S-GTE and 5S-FE. I used to have a 1990 MR2 Turbo, what did you specifically want to know? I purchased this book a few years ago from a main agent, It did take me some time to get it though. ;)

thanks for the reply,
basically i have given a mechanic a full bottom end to rebuild,
and hes struggling finding the settings for replacing crank, big ends etc, but i suppose hes going to need everything eventually to put it all back together, head bolts etc, whatever you could dig out would be greatly appreciated,
thanks again, Andy

Ok, starting from the crank here's a few:-
Main Bearing Caps(Crank to Block) - 600kg-cm (43ft-lb, 59Nm)
Connecting Rod Caps(Conrods to crank) - 680 kg-cm (49ft-lb, 67Nm)
Inner Oil Seal Retainer - 6 Bolts 95kg-cm (82 in-lb, 9.3Nm)
Flywheel - 8 Bolts (Apply Loctite or equiv) 1100kg-cm (80ft-lb, 108Nm
Drive Plate - 850kg-cm (61ft-lb, 83Nm)
Knock Sensor - 450kg-cm (33ft-lb, 44Nm)
Rear End Plate - 95kg-cm (82ft-lb, 9.3Nm)
Note-when installing Main bearing shells No3's is 23.0mm width whereas the rest are 19.2mm

Theres a few, let us know if you need anymore ;)

Cheers


[Edited by Delboy2 - 11/30/2003 2:02:44 AM]

thanks for that delboy,
that should keep us going for a bit,

dont go away i may need you again!!!!