Anyone know much about how the intellistart option is wired in, i had this installed by a clifford dealer and no problems, but a couple of months ago i had the coil packs replced, and the garage doing the work noticed that a wire from the alarm was attached to one of the coil packs.
He took this off and wired it to a permanent 12v feed, since then the intellistart has not worked. I spoke to a the clifford dealer who said that the wire has to go back to a positive on one of the coil packs, i have done this but it still doesnt work Any ideas anyone ??? Rich |
Pretty sure it goes to the negative side of the coil - see the intellistart PDF manual I sent you. It uses it to check the RPM.
Regards Micky |
Cheers Micky, wil try that out
Rich |
I think the wire your on about is the black/grey if so this has to go to the wire on the coil pack which pulses with the engine running!
Cheers Doc. |
All times are GMT +1. The time now is 01:19 PM. |
© 2024 MH Sub I, LLC dba Internet Brands