Deleting TGV's / Fault Code...
Am I right in thinking if I remove the motors from my tumble generator valves & swap them out for some gutted & welded ones the car won't go into limp mode provided the motors are still connected to the loom.
So it'll won't throw up a fault code up so I can drive it to get the (potential) fault code removed, then disconnect the motors & reap the rewards after remapping :luvlove: Cheers, Stuart |
IIRC, the flaps are spring loaded (and I think the other end isn't a motor but a location sensor), and if you take them apart and connect them together outside the housing then they won't be in the right location, so probably still raise an error code.
I do think, however, that there would be enough space for a second set of tgv housings next to the original ones, so you could run two housings and connect the connectors to the "spare" housings hung to the side of the engine. |
Originally Posted by Henrik
(Post 12038915)
IIRC, the flaps are spring loaded (and I think the other end isn't a motor but a location sensor), and if you take them apart and connect them together outside the housing then they won't be in the right location, so probably still raise an error code.
I do think, however, that there would be enough space for a second set of tgv housings next to the original ones, so you could run two housings and connect the connectors to the "spare" housings hung to the side of the engine. Next up to find someone who can knock teh code out for me :wonder: |
All times are GMT +1. The time now is 08:10 AM. |
© 2024 MH Sub I, LLC dba Internet Brands