Best place to buy injectors
Cut a long story short have a Gt3076R on my 2.0 and it made 426bhp been running that power for a while now but when it was mapped bob commented on how reflowed injectors are pants and was more than likely holding back the power, decided to finally sort it out and while I知 doing it will be buying fuel rails a Harvey trick up pipe and turning round the manifold so front facing Where痴 best place to get injectors ? Only looking for 800cc seen a few about for around 」400 just not that clued up on them Cheers Sam |
Originally Posted by Mustoe91
(Post 12036075)
Cut a long story short have a Gt3076R on my 2.0 and it made 426bhp been running that power for a while now but when it was mapped bob commented on how reflowed injectors are pants and was more than likely holding back the power, decided to finally sort it out and while I知 doing it will be buying fuel rails a Harvey trick up pipe and turning round the manifold so front facing Where痴 best place to get injectors ? Only looking for 800cc seen a few about for around 」400 just not that clued up on them Cheers Sam try alyn @ as performance http://asperformance.com/ |
Originally Posted by the shreksta
(Post 12036078)
|
Originally Posted by Mustoe91
(Post 12036080)
He may get some good business off me just messaged him about a trick up pipe |
|
got mine from asnu (recommended by bob) and are great injectors ,, uk company aswell so easy to work with
|
Originally Posted by Mustoe91
(Post 12036080)
He may get some good business off me just messaged him about a trick up pipe Sourced my Harvey Smith Uppipe from Alyn. Along with decat Hayward and Scott decat downpipe and a map from Andy Forrest I saw and additional 90bhp on my 05 wrx sti blobeye. |
Genuine Bosch injectors here:
http://www.dtafast.co.uk/dta_product...jector-1000cc/ They're 900cc at 3 bar, and 1000cc at 4 bar. |
Originally Posted by domino46
(Post 12036116)
got mine from asnu (recommended by bob) and are great injectors ,, uk company aswell so easy to work with
|
So far found DeatschWerk 750cc brand new for 」397 Injector Dynamics 725cc and 1000cc 」400 Now am I right in saying 1000cc is overkill for the targets I’m looking for ? But 750cc would be about right for 450/500bhp ? Sam |
Originally Posted by Mustoe91
(Post 12036184)
how much were they ? |
Originally Posted by Mustoe91
(Post 12036217)
So far found DeatschWerk 750cc brand new for 」397 Injector Dynamics 725cc and 1000cc 」400 Now am I right in saying 1000cc is overkill for the targets I知 looking for ? But 750cc would be about right for 450/500bhp ? Sam |
Originally Posted by Mustoe91
(Post 12036217)
So far found DeatschWerk 750cc brand new for 」397 Injector Dynamics 725cc and 1000cc 」400 Now am I right in saying 1000cc is overkill for the targets I知 looking for ? But 750cc would be about right for 450/500bhp ? Sam |
I run the 900cc on my 500hp 2.L engine, and they work really well. There's enough headroom to go higher if needed, but it will still start with no throttle input and idle quite happily.
|
Originally Posted by Mustoe91
(Post 12036217)
So far found DeatschWerk 750cc brand new for 」397 Injector Dynamics 725cc and 1000cc 」400 Now am I right in saying 1000cc is overkill for the targets I知 looking for ? But 750cc would be about right for 450/500bhp ? Sam they haven't made anything smaller than the 1050X kits for some time so not sure where you have seen those?? unless s/hand................... 1050X is one of the most stable and reliable injector sets we have used and you could get away with them in a std car |
Originally Posted by domino46
(Post 12036225)
depends on what you want to finish at really ,, mine are almost maxed at 530 so I would say 800cc would be my minimum choice
|
Originally Posted by stockcar
(Post 12036234)
they haven't made anything smaller than the 1050X kits for some time so not sure where you have seen those?? unless s/hand...................
1050X is one of the most stable and reliable injector sets we have used and you could get away with them in a std car |
Personally I'd go with ID1050 injectors from Alyn @ AS. That's what I'll be using.
|
Originally Posted by BrownPantsRacing
(Post 12036240)
Personally I'd go with ID1050 injectors from Alyn @ AS. That's what I'll be using.
|
ASP - my go to place for everything subaru when i'm not sourcing from breakers lol
|
I got Deatchwerks 850's direct,
Can also try H-Tune for em |
https://www.rallysportdirect.com/par...top-feed-850cc
https://h-tune.co.uk/deatschwerks-fu...arious-models/ 」525 from H-Tune for the 850's |
often cheaper (and possibly better service) from others already mentioned............
|
ID do 850 also, think I bought mine new from alyn as well
|
All times are GMT +1. The time now is 09:21 AM. |
© 2024 MH Sub I, LLC dba Internet Brands