3d Printed Newage Single DIN Blanking, Gauge/Switch Mount Plates
 

What is it?

A Newage single DIN blanking plate / adapter for gauges and switches


Options

Two options, either clip mount or screw mounted. Both can be blanking plates, adapters for up to 3 gauges (45mm / 52mm) and/or for mounting switches.

The clip mounted is easily fitted and removed from the front, it does however have a slight lip, and the 52mm gauge unit needs to protude out slightly, see image below. It clips to the grey trim panel and does not require any fixings.

The screw mounted one is flush to the face but requires 2 x course thread 5mm self tapping screws to fix it to the radio bracket. (same screws as used to mount the radio brackets to the dash inner panels).


Arrangements

Up to 3 gauges in each, and I can arrange them as you like, or add holes for switches. Just let me know in a PM


Cost

£15 delivered to the UK and gifted on paypal. PM me if interested!

Cheers for looking.

https://cimg8.ibsrv.net/gimg/www.sco...18d6134e99.jpg

52mm gauge clip in version




https://cimg0.ibsrv.net/gimg/www.sco...2510afafef.jpg


45mm gauge screw in type



https://cimg5.ibsrv.net/gimg/www.sco...f7322d1b6c.jpg

45mm gauge clip in type

Bump

Price Reduced

Do you think there will be room to fit 3 60mm gauages? like the 2nd and 3rd picture.

Thanks

Ian

Sadly not as the gap is not wide enough in a single din slot for 60mm gauge.

I could probably look at 60mm version of the dash top one though ;) LINK