OK - if the options in 2 way are "front and rear", then that's assuming you have full range speakers front and rear. Set it to 3 way "active" and see what options you have.

Should be something like:

LOW (sub) HPF 20-125hz
MID - HPF 50hz-1khz
MID - LPF 500hz - 3khz
HIGH - HPF 2khz - 8khz

Using the settings from the earlier post with a 12db slope, ignoring the LOW (sub).

Just seen your post. Set it to 3way.

Use my settings. Leave "level" at 0db. Don't touch EQ.

The 2 way mode is for full range speakers and a sub. So all you can set is the HPF (how low you want the full range to go).

MAKE SURE SPEAKER/RCA ARE CONNECTED THE RIGHT WAY FIRST.

So you don't try and run a load of bass through your tweeters...

Also, have you set the gains on the amp?

I will get into this tomorrow today has been a bit busy.