Hatchback cup holder
1 Attachment(s)
I seem to be missing the cup holder that inserts here ( see pic )
Does anyone know where I could source one online? Cheers |
On mine it was just a couple of foam pads at the bottom, no actual holders to speak of.
|
1 Attachment(s)
Originally Posted by fatboy_coach
(Post 11924138)
On mine it was just a couple of foam pads at the bottom, no actual holders to speak of.
His is like the pic I've attached |
Originally Posted by Wull
(Post 11924132)
I seem to be missing the cup holder that inserts here ( see pic )
Does anyone know where I could source one online? Cheers info here http://opposedforces.com/parts/impre...llustration_2/ |
You should try http://subarupartsdeal.com I've purchased from them before and the parts are OEM.
|
I used the parts fiche above and phoned my local Subaru dealer at lunch. That's them ordered plus the inner arches that I need as mine are goosed.
Cheers guys |
1 Attachment(s)
What's the deal with the 3 mats in this picture, I went and picked up my inner arch liners today and I had ordered all the relevant parts I needed for the cup holder but only the cup insert was in stock.
So I'm waiting for the 2 bigger looking mats and the smaller one which you can see pictured above the cup insert. My question is, what purpose does one of the big mats serve if the cup insert is going in on top of it? Cheers |
Originally Posted by Wull
(Post 11924515)
What's the deal with the 3 mats in this picture, I went and picked up my inner arch liners today and I had ordered all the relevant parts I needed for the cup holder but only the cup insert was in stock.
So I'm waiting for the 2 bigger looking mats and the smaller one which you can see pictured above the cup insert. My question is, what purpose does one of the big mats serve if the cup insert is going in on top of it? Cheers The "cupholder insert" can be fitted either way around. Without it you can fit two bottles. With it, it reduces the depth of one section suitable for a cup, so you can fit it at the front or back. The rubber mats insulate noise (plastic on plastic) and heat. |
Originally Posted by Don Clark
(Post 11924546)
The bottom of each section has a rubber mat.
The "cupholder insert" can be fitted either way around. Without it you can fit two bottles. With it, it reduces the depth of one section suitable for a cup, so you can fit it at the front or back. The rubber mats insulate noise (plastic on plastic) and heat. I didn't realise it could be fitted either way round especially as in the pic it's a certain way.....I just presumed that's the way it goes. |
Plus 10 hp for cup holder mats!
|
All times are GMT +1. The time now is 12:21 PM. |
© 2024 MH Sub I, LLC dba Internet Brands