What to tape up for shotblasters/coaters
Got my front hubs separated and front calipers with pistons out. What do i tape up? All the runners inside the hubs and over the piston chambers?
Also i know it sounds stupid but should i clean off all the grease etc prior to this? |
Calipers. Roll up tape and fill the pistons bores. Then use duct tape to cover the top. The tape underneath helps protect and stop the duct tape collapsing. Also the calipers half's were the brake fluid goes from one side to another. . Also the brake pipe fitting at of caliper. And bleed nipples.
Generally any bearing surface or fluid transfer areas. Once blasted get them cleaned and re cleaned and clean again to remove any grit Aye best to clean old the grease as stop contaminating the blasting grit |
Originally Posted by quattroowner
(Post 11887727)
Calipers. Roll up tape and fill the pistons bores. Then use duct tape to cover the top. The tape underneath helps protect and stop the duct tape collapsing. Also the calipers half's were the brake fluid goes from one side to another. . Also the brake pipe fitting at of caliper. And bleed nipples.
Generally any bearing surface or fluid transfer areas. Once blasted get them cleaned and re cleaned and clean again to remove any grit Aye best to clean old the grease as stop contaminating the blasting grit |
Cheers for taking the time to write - will be doing this before I send them off! thankyou
Ash |
All times are GMT +1. The time now is 03:43 AM. |
© 2024 MH Sub I, LLC dba Internet Brands