What to tape up for shotblasters/coaters
#1
Scooby Regular
Thread Starter
What to tape up for shotblasters/coaters
Got my front hubs separated and front calipers with pistons out. What do i tape up? All the runners inside the hubs and over the piston chambers?
Also i know it sounds stupid but should i clean off all the grease etc prior to this?
Also i know it sounds stupid but should i clean off all the grease etc prior to this?
Last edited by Ash Webster; 24 October 2016 at 10:04 AM.
#2
Scooby Regular
iTrader: (5)
Calipers. Roll up tape and fill the pistons bores. Then use duct tape to cover the top. The tape underneath helps protect and stop the duct tape collapsing. Also the calipers half's were the brake fluid goes from one side to another. . Also the brake pipe fitting at of caliper. And bleed nipples.
Generally any bearing surface or fluid transfer areas.
Once blasted get them cleaned and re cleaned and clean again to remove any grit
Aye best to clean old the grease as stop contaminating the blasting grit
Generally any bearing surface or fluid transfer areas.
Once blasted get them cleaned and re cleaned and clean again to remove any grit
Aye best to clean old the grease as stop contaminating the blasting grit
#3
Scooby Regular
Join Date: Apr 2014
Location: Loughborough
Posts: 303
Likes: 0
Received 0 Likes
on
0 Posts
Calipers. Roll up tape and fill the pistons bores. Then use duct tape to cover the top. The tape underneath helps protect and stop the duct tape collapsing. Also the calipers half's were the brake fluid goes from one side to another. . Also the brake pipe fitting at of caliper. And bleed nipples.
Generally any bearing surface or fluid transfer areas.
Once blasted get them cleaned and re cleaned and clean again to remove any grit
Aye best to clean old the grease as stop contaminating the blasting grit
Generally any bearing surface or fluid transfer areas.
Once blasted get them cleaned and re cleaned and clean again to remove any grit
Aye best to clean old the grease as stop contaminating the blasting grit