Help Non start condition
Firstly sorry my first post is asking for help. I have a 95 Wrx and recently removed the inlet manifold, power steering pump and alternator and replaced with painted/dipped parts. I labelled everything up so am sure have put everything back correctly.
When I went to fire up am getting no fuel to the rails I get two clicks no cel comes on at all only lights I get on dash is battery antilock brake oil and hand brake the car will crank over but not fire up. So far I have checked: Confirmed all plugs connected correctly, Confirmed all earths connected, Checked fuses under bonnet and under dash no issues Checked plugs on ecu and no power Struggling to get to the bottom of this issue so any pointers would be great |
Also fitted inlet spacers when refitted manifold
|
I can't remember the layout or if its possible, but are flow and return on the fuel rails connected the right way round? Regulator might prevent flow in wrong direction?
|
Yeah connected correctly
|
Crank sensor unconnected or wiring damaged when you removed alternator?
|
Cam sensor and injector #2 mixed up?
Is there no CEL with just ignition on? |
Crank sensor connected, cam sensor and injector wiring correct way round, no cel at all even with ignition in on position
|
Was the CEL lamp working before you stripped the inlet?
Checked fuses,including SB ones and the fusible link. |
Originally Posted by ossett2k2
(Post 11853633)
Was the CEL lamp working before you stripped the inlet?
Checked fuses,including SB ones and the fusible link. |
No power to the ECU,car got an immobiliser?
Did you check fuses with a meter or just visually? |
Checked the fuses with multimeter, there is an imobileser think that's me next check but that allows me to get the lights mentioned in my first post no lights at all until press the alarm button to deactivate
|
All 3 under bonnet loom plugs checked and connected? 2 square LH and 1 round RH
|
Originally Posted by ossett2k2
(Post 11853655)
All 3 under bonnet loom plugs checked and connected? 2 square LH and 1 round RH
|
Bad earth on your newly painted/dipped Inlet manifold ??
Mick |
I was thinking that but I had dremelled it to the metal but it is sitting on 10mm spacers
|
Finally got her started, removed everything down to the inlet manifold checked harness wasn't happy with the condition of the cam plug, soldered on a new cam plug, refitted everything except for the inlet manifold spacers. Fired up on first turn of the key
|
Great stuff.glad you sorted it.
|
Only takes one small thing on a modern car.
|
All times are GMT +1. The time now is 03:04 PM. |
© 2024 MH Sub I, LLC dba Internet Brands