boost/ misfire issue
Hello everyone
I bought a 2000 my00 uk turbo w plate it was running perfect for about a month then I had this pulsating issue. It has 170 on the clock the ecu is a z7 ae802 I put fresh plugs in bkr7e gapped to .6 mm, oil, filter and fuel filter. no change new maf original subaru insert made it a little bit better. New pipework from solenoid to turbo to actuator with 1.2mm pill still in place no change. New lambda no change. Second hand boost solenoid no change again. I've got a boost gauge on order to check the boost and vac. Could a bad maf foul fresh plugs? It drives fine upto quarter throttle anything over and it pulses feels like an on off switch until 4.5-5k revs. I drilled the pill out to 1.3mm incase it was overboost but still the same. Also reset the ecu with every change i've made. No codes stored 1 day it was driving great then the next it was like this please help me... |
Fuel filter check it
|
Already done that, it says up there somewhere.
Also run on vpower nitro |
Originally Posted by symunky
(Post 11387996)
Already done that, it says up there somewhere.
Also run on vpower nitro |
Good news.... but what caused them to crack??? Doesn't sound good!
|
It was either me gapping them with a hammer, or tightening them up in the very cramped side of the engine...
Either 1 I was prepared for the second time, and I did the swap flawlessly :) Gotta wait for my 1.2mm pill to be delivered now after I drilled it out to 1.3mm |
Back to how she was again...
Power coming on in in waves anything over quarter throttle... Please help me |
air leaks...? I had same problem..turned out I had a air leak on the inlet manifold..also I gaped my plugs at 6.5...shore I read you had gaped at 6??
|
It is overboosting to 1.3 bar then down to .9 then up again and so on.
Just fitted my gauge this morning... Any ideas now |
bcs,air leak, if you was to do a smoke test it would show any escaping air..
|
Would an air leak cause overboost though?
And Im going to get some carb/brake cleaner in the morning and try that even though I bought a second hand 1. |
Originally Posted by symunky
(Post 11394162)
Would an air leak cause overboost though?
And Im going to get some carb/brake cleaner in the morning and try that even though I bought a second hand 1. |
Vac on the gauge is -.6 holding steady does sound about right.
|
Would an ebc be a good option to set the boost at 1 bar?
|
Fitted a gizzmo ms ibc and set it at 1 bar it runs perfect...
|
All times are GMT +1. The time now is 07:00 PM. |
© 2024 MH Sub I, LLC dba Internet Brands