Reason i ask is i have just fitted a new downpipe after a couple of failed attempts to get a good fit. One was poor fit other was HKS but company set a Jap fit one out.

I just wanted to see if my tailpipe is sat out as far as it should be

 

Here's mine

 

Thanks Jon

Possible to get any more of a side angle??

 

From that pic mine looks ok, Phew!

Lol at how the pic was taken

 

I can take a couple for you tomorrow

 

Thankfully it was dry

 

Is this any better

 

Thanks bud. The last downpipe pulled the backbox in quite a lot but this seems alright.

 

Mine

YouTube - Schweeet !

 

Thx Jon and 53WRX seems pretty much as mine sits. My concern was it was sat in far but the exhaust hangers are pretty much straight and they are quite a stumpy tailpipe

 

If the hangars are straight then it is sitting right

 

I say straight but actually slightly towards the fornt of the car not by much but knew if that was the case then fit would be good.

Will keep an eye at the shows see how it matches up.

 

A few pic's of mine, hope it helps.

 

Having looked at yours, I think I need to go and clean mine

 

^^^ Your a gent that seems about **** on with mine.

Lovely machine you have there.

PS where did you get the carbon heat shield? is it held by 3M tape or glued

 

They are normally 3m'd and screwed in place. Scoobyparts has them I believe and there's plenty on fleabay

 

Got it off ebay, it's stuck on with 3M tape but I had to put some black silicone around the edges as there was a small gap and didn't look quite right.

 

Check out the exterior/carbon parts area of here - £45

Scooby Clinic | The UK's Largest Independent Subaru Specialists | 01246 590 807 - Chesterfield S42 6QX

 

Here's mine :-)

 

I think is the sort of angle you're after

 

Excellent thanks guys