Just fitted a Milltek system pic and comment
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Feb 2008
Location: Rutland
Posts: 448
Likes: 0
Received 0 Likes
on
0 Posts
Just fitted a Milltek system pic and comment
Following a swap with Scoobydoo69 above is a picture of the tail end of my 2.75" Milltek cat-back system. I previously had a tsl de-res centre section and Prodrive bb. Whats the difference?
Well the pipe work seems miles bigger even though its only 1/4" difference in diameter.
The sound is not as deep at idle or pootling around just different and when you press on the it is a lot harder than my previous set up. The quality of the system is excellent, the welds are very neat and the fit perfect.
Rich
#5
Scooby Regular
Join Date: Aug 2005
Location: Bebind the wheel of my red rice rocket
Posts: 5,585
Likes: 0
Received 0 Likes
on
0 Posts
I'm on my 3rd milltek system now, firstly a 2.75" sports cat then 3" straight through on the STI, and now a non res/non valved system on the RS. Great kit
Regarding the discolouring, i've had the problem myself but do know others who have. On each occasion milltek have replaced on proof of purchase
Regarding the discolouring, i've had the problem myself but do know others who have. On each occasion milltek have replaced on proof of purchase
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
matt12
ScoobyNet General
64
16 September 2015 09:16 PM
matt12
Engine Management and ECU Remapping
4
14 September 2015 09:36 AM