fitting oil temp and pressure guage
16 April 2011, 04:24 PM
#1
Scooby Newbie
Thread Starter
fitting oil temp and pressure guage
hi guys, i have a boost, oil temp and oil pressure guages laying around so was going to put them in my classic, just wondering if i can wire these to existing sensors or looms anywere or if i have to insert new sensors?
16 April 2011, 04:58 PM
#3
Scooby Regular
iTrader: (12)
Join Date: Apr 2007
Location: Littlehampton
Posts: 2,427
Likes: 0
Received 0 Likes
on
0 Posts
New wires and sensors, get the Scoobyworld or similar install kit so you can take oil temp from above Cylinder 3 and oil pressure from the same point as OE.
17 April 2011, 12:07 PM
#6
AFAIK, most sensors are brand specific, ie: you can't use any old sensor, they have to be whatever brand the gauge is, or it won't be calibrated.......possibly, or might not even read.
What make of gauges are they? Try the gauge sellers/importers for help.
What make of gauges are they? Try the gauge sellers/importers for help.
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
JonMc
Subaru Parts
22
06 February 2016 09:50 PM
Bazil_SW
Engine Management and ECU Remapping
24
21 September 2015 11:55 PM