knock sensor problem
03 August 2007, 06:07 PM
#1
Scooby Regular
Thread Starter
iTrader: (11)
Join Date: Jul 2006
Posts: 683
Likes: 0
Received 0 Likes
on
0 Posts
knock sensor problem
can anyone help?
the check engine light is showing fault code 22 which is apparently knock sensor,
does anyone have one for sale
and can anyone advise on the fitting and where it is and how easy
many thanks
the check engine light is showing fault code 22 which is apparently knock sensor,
does anyone have one for sale
and can anyone advise on the fitting and where it is and how easy
many thanks
03 August 2007, 06:34 PM
#2
Scooby Regular
iTrader: (4)
Join Date: Feb 2007
Location: kent
Posts: 687
Likes: 0
Received 0 Likes
on
0 Posts
post a wanted ad in the wanted section i got mine from subaru 70 quid!! but im sure you will get one cheaper i done mine a couple of months back if you have a classic you will have to remove the ic it is located on the block you will need a extention bar to reach it can be a bit fiddly but shouldnt take to long
03 August 2007, 06:38 PM
#3
Scooby Regular
iTrader: (4)
Join Date: Feb 2007
Location: kent
Posts: 687
Likes: 0
Received 0 Likes
on
0 Posts
Knock sensor can be found above cylinder 4 this is located on the left hand side towards the back of the block " starter motor side ". It’s a small back sensor with one wire and one bolt attaching it to the block.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM