H4 xenons question
#1
Scooby Regular
Thread Starter
iTrader: (3)
Join Date: Jul 2006
Location: Essex
Posts: 466
Likes: 0
Received 0 Likes
on
0 Posts
H4 xenons question
When switching to high beam should the low beams be switching off??
And is there anyway to keep them on? or is this bad?
Thanks.
Ps, i'm also using the loom that come with the kit, and these are new type twin xenon filament with 4 ballasts. testing for a frind who's importing them.
will try to post some b4 and after pics
And is there anyway to keep them on? or is this bad?
Thanks.
Ps, i'm also using the loom that come with the kit, and these are new type twin xenon filament with 4 ballasts. testing for a frind who's importing them.
will try to post some b4 and after pics
Last edited by wayno; 01 May 2007 at 10:55 PM.
#4
When switching to high beam should the low beams be switching off??
And is there anyway to keep them on? or is this bad?
Thanks.
Ps, i'm also using the loom that come with the kit, and these are new type twin xenon filament with 4 ballasts. testing for a frind who's importing them.
will try to post some b4 and after pics
And is there anyway to keep them on? or is this bad?
Thanks.
Ps, i'm also using the loom that come with the kit, and these are new type twin xenon filament with 4 ballasts. testing for a frind who's importing them.
will try to post some b4 and after pics
Hope this helps
Kev
Thread
Thread Starter
Forum
Replies
Last Post
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM