Jacey Boy

Does anyone know how to do this?, I am at work and the manual for the car is at home

Jacey Boy

Infact I do have the manual here and it doesnt mention it

D1CCY

Vertical adjuster is at back/bottom of unit in the middle. A sort of knurly edge thing in a hole. Use a medium/large phillips screwdriver to rotate. Side to side adjuster is similar but on the radiator side of each lamp near the top. Can't remember which way to turn for up/down etc but if you're aiming it at a wall it will be pretty obvious.

Jacey Boy

Thanks for that, must be a pain to access?

D1CCY

No screwdriver just goes in from top.

Butty

iTrader: (2)

I only used a ring spanner - 8 or 10mm? Perhaps screwdriver is used on classic cars?
Up/down is controlled by adjusting nut on back of motor body towards bottom of unit.
Side to side movement on nut at top of headlight unit.
Access was mildly fiddly but not too bad.

Nick

D1CCY

No, I managed with Phillips driver on 03 Blobeye, much easier than spanner as you can easily twiddle it in the adjuster and watch the aim on a wall at the same time.