I recently bought a set of used Prodrive UK300 lights for the 02 bugeye wrx. Lights are great, but a bulb just burned out.

How do I change the lowbeams? Do I need to remove the lights to change them?

Thanks

 

I don't think so AFAIR - they are H7 bulbs and once you've taken the rubber boot off the back of the respective light (upper housing = dipped beam I seem to remember), they are held in by spring clips like most other bulbs.

 

hi mate, I have a UK 300, the side light bulbs are underneath where the full beam bulb is, removed by twisting them, you should be able to see it through the lens, not a lot of room.
The main & full beam bulbs are as Apple said above, not too hard to get at, go get abit more room if you remove the air intake pipe if its one that side.

PS Apple hope your keeping ok, you missed quite abusy meet last nite, see you at the next one.
Mark.

 

The cold's getting better - I think the curry last night helped it on it's way slightly

Seems like there's a growing crowd at the meets - I'll hopefully be at the next one as things should have quietened down a bit by then in several areas etc.

 

Thanks for the info! I now have a new set of Raybrig H7's