hi all done my 1st ecu reset,

connected black & green plugs, then turned ignition on, held throttle completey down for a few sec, then hels it half way for a cple of more secs, while doing this the cooling fan kept on starting and stopping, and heard lots of clicks,
then started the engine to go for a little run around the block, when reversing of the drive the check light started to flash, went around the block nice and steady, but the turbo was not working very well at all, like it was really hesistent and lazy,
got back and unplugged the leads, and turned the ignition on, the light has stopped flashing,

is this all ok?

i was told that when it starts to flash it means that the ecu is reset!!!!

about to try the car now to see if the turbo is back to how it was

I'll be back

 

well every seems to be ok thank god,

so if after now that i have done this if there was a problem would the Engine check light still be flashing?

by the way it is a ecu from the ppp