Dash lighting pwr supply
#1
Scooby Regular
Thread Starter
Join Date: Jun 2002
Location: Ayrshire
Posts: 350
Likes: 0
Received 0 Likes
on
0 Posts
I'm about to fit a Boost gauge to my STi7 (A pillar), can anyone advise on where to T into the dash lighting circuit, wire colour, easiest place to access etc?
cheers
Andy
cheers
Andy
#2
I had to ask the same thing a while back....... the answer I got was:
use the PURPLE wire from the back of your fog light switch for the live feed.......
It was very easy to find/get at - took me about 10 minutes from start to finish. I have to admit I was a little careless and blew the tiny little bulb in the switch (somehow!! it may not have been working before, but I don't know) but this too was easy to change.
Edited to say : "Doh! just noticed its an STi 7 - mine a classic MY99, however, after talking to a chap with an MY02, I believe te advice is the same.........
I loosened the panel enough to get behind it, and popped the switch out forwards.......
[Edited by Fat Blerk - 1/14/2003 2:11:01 PM]
use the PURPLE wire from the back of your fog light switch for the live feed.......
It was very easy to find/get at - took me about 10 minutes from start to finish. I have to admit I was a little careless and blew the tiny little bulb in the switch (somehow!! it may not have been working before, but I don't know) but this too was easy to change.
Edited to say : "Doh! just noticed its an STi 7 - mine a classic MY99, however, after talking to a chap with an MY02, I believe te advice is the same.........
I loosened the panel enough to get behind it, and popped the switch out forwards.......
[Edited by Fat Blerk - 1/14/2003 2:11:01 PM]
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM