Hi all...was looking to remove the red fog light cluster for a clear one on the rear of my 2008 sti hatch,has anyone done this conversion and if so where did you purchase the clear cluster.
any help would be much appreciated.

 

Subaru - part number is 84912FG061

 

PM Rob84 on here. That's where I got mine from!

 

Got mine from japanparts.com

 

Many thanks guys

 

Does anyone know, is it possible to remove only red plastic inside the fog light? Instead of replacing the whole fog light cluster.

 

Hi mate....I wondered too if the red insert could be removed ,and even though the red insert is a separate item the two halves of the light cluster cannot be separated.
If you are trying to do this to rid yourself of the odd looking rear fog light your best option is to buy a new rear light cluster with a clear lens.i got mine from www.japanparts.com.don't forget you'll have to buy a red bulb to compensate for loosing the red lens.

 

Thanks for the reply, much appreciated.

I will get one at japanparts then, or will try to find cluster in the UK first, since my car is LHD and would need left clear cluster, which you guys already have.

 

Sorry man didn't realise you had left hand drive though I would have assumed that the rear fog light would have been the same side regardless of left or right hand drive.

 

Thread revival:


Is this part easy to swap out, i.e. does it unscrew or do you need to do the oven trick to weaken the mastic.


Seems by the illustration in the below link that its just nuts and bolts.


https://www.japanparts.com/parts/detail/23362


Thanks,
Robert.

 

It is very easy to replace whole lamp. As you already recognized, there are only 3 bolts and a bulb connector to unplug. No oven/eating needed.
Most crappy part is to remove trunk door inner lining, be careful not to break plastic rivets.

 

That's great, and thanks for the illustrations.


The above is to remove the whole unit, but to use this part below it would seem I need to separate the lens from the unit?


https://www.japanparts.com/parts/detail/23362

 

Part on your picture is a complete lens AND body (see title). Installation is straightforward.

However on your picture it looks like this is only a lens, but it is not. This is a complete lamp unit. Lens only is not even available to buy.

Picture from the backside:

 

Brilliant, thank for clearing this up. This is where I thought the oven was going to be involved in separating the two parts, but not now!

 

I have done this and put 2 led fog lights in the bumper where the reflectors were so I know have 2 reversing lights which are also led lights so they are nice and bright and 2 led fog lights which look awesome when on