Cluster swap issues
#1
Scooby Regular
Thread Starter
iTrader: (14)
Join Date: Mar 2013
Location: Bedfordshire
Posts: 2,417
Likes: 0
Received 0 Likes
on
0 Posts
Cluster swap issues
Hi all just spent a fair while trawling through the internet, and I don't think I have found an answer to my issue with the cluster swap I want to do.
Here are the main points:-
2004 Blobeye pre widetrack STi cluster (non DCCD) into a 2005 Hawkeye WRX.
The 3 loom plugs fit no problem and most of it works except the following:-
ABS light on permanently (seen the relay job)
No auto headlight light (blobs did not have this)
Fog light warning does not light when the fogs are on.
CEL light comes on after a few seconds running with P2035 code
as soon as I put the old cluster back in the CEL goes out.
any suggestions?
Cheers
Here are the main points:-
2004 Blobeye pre widetrack STi cluster (non DCCD) into a 2005 Hawkeye WRX.
The 3 loom plugs fit no problem and most of it works except the following:-
ABS light on permanently (seen the relay job)
No auto headlight light (blobs did not have this)
Fog light warning does not light when the fogs are on.
CEL light comes on after a few seconds running with P2035 code
as soon as I put the old cluster back in the CEL goes out.
any suggestions?
Cheers
Thread
Thread Starter
Forum
Replies
Last Post
crazyspeedfreakz
Wanted
17
05 October 2015 07:19 PM
M4RKG
General Technical
3
30 September 2015 07:51 PM