Classic front indicator
#2
Scooby Regular
iTrader: (2)
One screw on top inner edge into headlight, you can see it with the bonnet up. Replace with stainless if you can
Then PULL the indicator straight forwards, it's on a ball and socket joint so needsa good pull, the straighter the better.
Mine, of course, snapped the ball off the indicator. I repaired it with epoxy resin and a small screw to build the epoxy round, and it's been fine for ten years!
A bit of grease round the ball and in the socket will aid removal in future.
Then PULL the indicator straight forwards, it's on a ball and socket joint so needsa good pull, the straighter the better.
Mine, of course, snapped the ball off the indicator. I repaired it with epoxy resin and a small screw to build the epoxy round, and it's been fine for ten years!
A bit of grease round the ball and in the socket will aid removal in future.
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
MH-Racing
Subaru Parts
18
18 October 2015 04:49 PM