Door card removal
#2
Scooby Regular
iTrader: (19)
easy
1. put your fingers near the bottom of the door card and give it a good yank. That should unclip the 3-4 clips that are on there
2. Prise up the door switch going from front first tilting it up gently and pulling forward. Be careful of the rear plastic lug.these break easily if you pull from back first so don't do that !! Unclip the window switch connector
3. Behind the door switch is a gold screw. Phillips on it and put somewhere safe.
4. Unclip the door handle surround. This is a case of carefully pulling it, it will sound bad as you unclip it but don't worry.
5. Small screw cover in the shape of a square low down at back of door card. remove carefully with flat blade screwdriver.
6. Behind the cover is another gold screw, phillips again
7. Then push the door card up to clear the clips at the top and you will have done it.
8. Have a nice drink to celebrate
P.S The door card will come off without unscrewing the door handle. If you decide to unscrew that be wary of moving the rods that connect the handle to the regulator
1. put your fingers near the bottom of the door card and give it a good yank. That should unclip the 3-4 clips that are on there
2. Prise up the door switch going from front first tilting it up gently and pulling forward. Be careful of the rear plastic lug.these break easily if you pull from back first so don't do that !! Unclip the window switch connector
3. Behind the door switch is a gold screw. Phillips on it and put somewhere safe.
4. Unclip the door handle surround. This is a case of carefully pulling it, it will sound bad as you unclip it but don't worry.
5. Small screw cover in the shape of a square low down at back of door card. remove carefully with flat blade screwdriver.
6. Behind the cover is another gold screw, phillips again
7. Then push the door card up to clear the clips at the top and you will have done it.
8. Have a nice drink to celebrate
P.S The door card will come off without unscrewing the door handle. If you decide to unscrew that be wary of moving the rods that connect the handle to the regulator
Last edited by SwissTony; 05 January 2014 at 02:27 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM