Bucket Seats with Standard Seatbelts
23 December 2013, 12:53 AM
#1
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Jan 2008
Location: Lancashire (Not Dundee Anymore)
Posts: 837
Likes: 0
Received 0 Likes
on
0 Posts
Bucket Seats with Standard Seatbelts
Anyone running bucket seats with standard 3 point Seatbelts? Or has everyone gone with harnesses? I'm not keen on running harness on my daily and I've seen a guy on NASIOC have a nightmare sorting his seatbelt buckle with his Recaro Pole Positions.
Last edited by JamesDundee; 23 December 2013 at 12:54 AM.
23 December 2013, 04:16 AM
#2
Hi there
Yes you should be able to use OE harness with yours bucket seats,but this will depends too on the rials and on the seat itself
On BuddyClub rails you can easily mount OE seatbelt buckle and on the seat will depends if its not too wide and can touch side where is seatbelt itself(on B-Pillar)
Jura
Yes you should be able to use OE harness with yours bucket seats,but this will depends too on the rials and on the seat itself
On BuddyClub rails you can easily mount OE seatbelt buckle and on the seat will depends if its not too wide and can touch side where is seatbelt itself(on B-Pillar)
Jura
23 December 2013, 06:21 AM
#3
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Jan 2008
Location: Lancashire (Not Dundee Anymore)
Posts: 837
Likes: 0
Received 0 Likes
on
0 Posts
Thanks, I was planning on buddy club rails. But do you not get the issue of either struggling to thread the belt through the harness hole or trying to fit it over the top and squeeze it down the side?
23 December 2013, 10:03 PM
#4
We are never have issues with the normal seatbelts on our seats,we are used BuddyClub Rails and we are fitted Seatbelt buckle on the rails
But you can have issue with side of the seats,some seats are wider than OE and this can cause few issues with adjustability of the seat
Without the fitting them,you don't know how or if will be possible to use OE seatbelts
Jura
Thread
Thread Starter
Forum
Replies
Last Post