my01 dash !?
#1
Scooby Regular
Thread Starter
Join Date: Nov 2001
Location: sheffield
Posts: 4,093
Likes: 0
Received 0 Likes
on
0 Posts
can anyone tell me how to take the dash bits off the my01
i know theres how to take the cup holder out and thats about it as the vents seem to want to come out if i take that bit off,
also after taking the screw off the door bit(elec. window) do i just yank it off.
also on the corner vents how do i take that off?
i know theres how to take the cup holder out and thats about it as the vents seem to want to come out if i take that bit off,
also after taking the screw off the door bit(elec. window) do i just yank it off.
also on the corner vents how do i take that off?
#2
I posted a similar thread earlier for my MY01 and Zippy came back with the following useful info regarding door trim:
"Once you have removed the 2 screws from the release handle and at the bottom of where you grab to close the door, take out the window switch unit and disconnect from the wiring loom, if i remember right there is another screw underneath where the switch unit sits take this out and then gently pull the panel away from the door starting at the bottom (2 grommets bottom and 2 each side)when the panel is loose lift it over the 2 plastic clips at the top of the door.
I had the said little rattle that p*ssed me off something rotten, the way i cured it was to glue all the grommets (poppers)directly to the door then put the panel back on and no more rattle.
Zippy. "
"Once you have removed the 2 screws from the release handle and at the bottom of where you grab to close the door, take out the window switch unit and disconnect from the wiring loom, if i remember right there is another screw underneath where the switch unit sits take this out and then gently pull the panel away from the door starting at the bottom (2 grommets bottom and 2 each side)when the panel is loose lift it over the 2 plastic clips at the top of the door.
I had the said little rattle that p*ssed me off something rotten, the way i cured it was to glue all the grommets (poppers)directly to the door then put the panel back on and no more rattle.
Zippy. "
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM