Defi BF controller wiring??
#1
Defi BF controller wiring??
Fitting defi BF gauges tomorrow- turbo boost, oil temp & oil pressure. Sti 2004ver8. Got oil temp adaptor for fitting beside cylinder 3 and oil pressure adaptor from Scoobyclinic for allowing both original and Defi pressure sensors to be inserted below alternator (I've since learn't that I don't actually need this bit of kit- £40!!!??).
This is how i'm going to connect Defi link controller power wires??-
red (permanent live) to blue/red wire to stereo,
orange (switched ignition live) to ignition wire to cig lighter,
black (ground/earth) to dash frame.
white (illumination) wire to illumination wire on cig lighter??? Is this illumination wire for the controller (i.e. so controller will only light up when side/headlights are on?)?- will this have same effect on gauges??? Thought they would need switched ignition illumination as have black faces and need illumination to be seen (i.e. when headlights/cig lighter are off during daylight)!!!! or does controller sort this out even though illumination wire to it is run off of lights???
Used multimeter to check all feeds.
This is how i'm going to connect Defi link controller power wires??-
red (permanent live) to blue/red wire to stereo,
orange (switched ignition live) to ignition wire to cig lighter,
black (ground/earth) to dash frame.
white (illumination) wire to illumination wire on cig lighter??? Is this illumination wire for the controller (i.e. so controller will only light up when side/headlights are on?)?- will this have same effect on gauges??? Thought they would need switched ignition illumination as have black faces and need illumination to be seen (i.e. when headlights/cig lighter are off during daylight)!!!! or does controller sort this out even though illumination wire to it is run off of lights???
Used multimeter to check all feeds.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM